Numerical simulation of two-phase separation in T-junction with experimental validation
DOI:
https://doi.org/10.15282/jmes.12.4.2018.17.0363Keywords:
Two-phase separation, T-junction, numerical simulation, slug flowAbstract
Liquid carryover in T-junction due to splitting nature of two-phase flow causes serious issues for downstream equipment which is not designed to handle excessive liquid. In this paper, the phenomena of liquid carryover in T-junctions were analyzed using the Volume of Fraction (VOF) together with the k-ε turbulence model. T-junction separation efficiency was measured through mass flow rate fraction of air and water between the branch and main arm over a range of diameter ratios 0.6 to 1.0, water superficial velocity 0.186 to 0.558 m/s and air superficial velocity 4 to 8 m/s. The results showed simulation model was successfully validated with average deviation of less than 5% and can be used to predict phase split of slug flow in T-junction. The numerical model confirmed the significant influence of diameter ratio and superficial velocities of air and water on phase split. Reduced T-junction delivers better separation performance compared to regular T-junction. In slug flow regime, T-junction’s performance can be improved by either decreasing air velocity or increasing water velocity. A new dimensionless parameter, namely the area under the curve of separation efficiency (S), was proposed and proved as a qualified judging criteria for evaluating phase separation efficiency of T-junctions.
References
Saieed, A., Two-phase separation in a T-junction, MSc Thesis, Universiti Teknologi PETRONAS, 2017.
Shoham, O., Brill, J.P., Taitel, Y., Two-phase flow splitting in a tee junction-experiment and modelling. Chemical Engineering Science 1987, 42, 2667–2676.
Wren, E., Geometric effects in phase split at a large diameter T-junction, Doctoral Thesis, University of Nottingham, 2001.
Baker, G., Clark, W.W., Azzopardi, B.J., Wilson, J.A., Controlling the phase separation of gas–liquid flows at horizontal T-junctions. AIChE J. 2007, 53, 1908–1915.
He, K., Wang, S., Zhang, L.-Z., Transient split features of slug flow at an impacting micro-T-junction: A numerical study. International Journal of Heat and Mass Transfer 2017, 112, 318–332.
Taitel, Y., Dukler, A.E., A model for predicting flow regime transitions in horizontal and near horizontal gas-liquid flow. AlChE Journal (Vol. 22, No. 1) 1976, 47.
Liu, Y., Li, W.Z., Numerical simulation on two-phase bubbly flow split in a branching T-junction. Int. J. Air-Cond. Ref. 2011, 19, 253–262.
Lu, P., Zhao, L., Deng, S., Zhang, J., et al., Simulation of two-phase refrigerant separation in horizontal T-junction. Applied Thermal Engineering 2018, 134, 333–340.
Lun, I., Calay, R.K., Holdo, A.E., Modelling two-phase flows using CFD. Applied Energy 1996, 53, 299–314.
Cook, M., Behnia, M., Bubble motion during inclined intermittent flow. International Journal of Heat and Fluid Flow 2001, 22, 543–551.
Lörstad, D., Fuchs, L., High-order surface tension VOF-model for 3D bubble flows with high density ratio. Journal of Computational Physics 2004, 200, 153–176.
Zhou, L., Liu, D., Ou, C., Simulation of Flow Transients in a Water Filling Pipe Containing Entrapped Air Pocket with VOF Model. Engineering Applications of Computational Fluid Mechanics 2011, 5, 127–140.
Taha, T., Cui, Z.F., CFD modelling of slug flow in vertical tubes. Chemical Engineering Science 2006, 61, 676–687.
Ujang, P.M., Lawrence, C.J., Hale, C.P., Hewitt, G.F., Slug initiation and evolution in two-phase horizontal flow. International Journal of Multiphase Flow 2006, 32, 527–552.
Ujang, P.M., Pan, L., Manfield, P.D., Lawrence, C.J., et al., Prediction of the translational velocity of liquid slugs in gas-liquid slug flow using computational fluid dynamics. Multiphase Science and Technology 2008, 20, 25–79.
Febres, M., Nieckele, A.O., Fonseca, R., Three-dimensional unit slug in a horizontal pipeline, in: 7th International Conference on Multiphase Flow, Florida USA 2010.
Ban, S., Numerical simulation of two-phase slug flow regime in horizontal pipe, MSc Thesis, Universiti Teknologi PETRONAS, 2017.
Saieed, A., Pao, W., Hewakandamby, B., Azzopardi, B.J., et al., Experimental investigation on the effect of diameter ratio on two-phase slug flow separation in a T-Junction. Journal of Petroleum Science and Engineering 2018, 170, 139–150.
Saieed, A., Sam, B., Pao, W., Hashim, F.M., Numerical investigation of side arm gas volume fraction in two phase T-junction. Journal of Mechanical Engineering and Sciences 2016, 10, 2311–2323.
Baker, O., Design of pipelines for the simultaneous flow of oil and gas, in: Fall Meeting of the Petroleum Branch of AIME, Society of Petroleum Engineers, 1953.
Rusdin, A., Computation of turbulent flow around a square block with standard and modified k-ε turbulence models. International Journal of Automotive and Mechanical Engineering 2017, 14, 3938–3953.
Halim Abd, M.A., Nik Mohd, N.A.R., Mohd Nasir, M.N., Dahalan, M.N., The Evaluation of k-ε and k-ω Turbulence Models in Modelling Flows and Performance of S-shaped Diffuser. International Journal of Automotive and Mechanical Engineering 2018, 15, 5161–5177.
Saieed, A., Pao, W., Hashim, F.M., Effect of T-junction diameter ratio on stratified-wavy flow separation. Journal of Natural Gas Science and Engineering 2018, 51, 223–232.
Saieed, A., Pao, W., Ali, H.M., Prediction of phase separation in a T-Junction. Experimental Thermal and Fluid Science 2018, 97, 160–179.
Das, G., Das, P.K., Azzopardi, B.J., The split of stratified gas–liquid flow at a small diameter T-junction. International Journal of Multiphase Flow 2005, 31, 514–528.
Roberts, P.A., Azzopardi, B.J., Hibberd, S., The split of horizontal semi-annular flow at a large diameter T-junction. International Journal of Multiphase Flow 1995, 21, 455–466.
Zetzmann, K., Phasenseparation und Druckelufall in Zweiphasig Durchstroemten Vertikalen Rohrabzweigungen, Doctoral Thesis, University of Hannover, 1982.
Griston, S., Choi, J.H., Two-phase flow splitting at side-branching tees, in: SPE Western Regional Meeting, Society of Petroleum Engineers, 1998.
Shoham, O., Arirachakaran, S., Brill, J.P., Two-phase flow splitting in a horizontal reduced pipe tee. Chemical Engineering Science 1989, 44, 2388–2391.
Azzopardi, B.J., The Effect of Side Arm Diameter on Phase Split at T-Junctions, in: SPE Annual Technical Conference and Exhibition, Houston, Texas, USA 1999.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2018 The Author(s)
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
