Variation of Car Cabin Temperature Influenced by Ventilation under Direct Sun Exposure

Authors

  • M.S.F. Mansor Research Department, Engineering Division, Perusahaan Otomobil Nasional (PROTON) Sdn. Bhd. HICOM Industrial Estate, Batu 3, P.O. Box 7100, 40918, Selangor Darul Ehsan, Malaysia
  • U.Z. Abd Rahman Research Department, Engineering Division, Perusahaan Otomobil Nasional (PROTON) Sdn. Bhd. HICOM Industrial Estate, Batu 3, P.O. Box 7100, 40918, Selangor Darul Ehsan, Malaysia
  • M.S. Zainal Abidin Research Department, Engineering Division, Perusahaan Otomobil Nasional (PROTON) Sdn. Bhd. HICOM Industrial Estate, Batu 3, P.O. Box 7100, 40918, Selangor Darul Ehsan, Malaysia
  • M.Z. Md Zain Department of Applied Mechanics and Design, Faculty of Mechanical Engineering Universiti Teknologi Malaysia, 81310 UTM Skudai, Johor, Malaysia
  • M.R. Md Yusof Department of Applied Mechanics and Design, Faculty of Mechanical Engineering Universiti Teknologi Malaysia, 81310 UTM Skudai, Johor, Malaysia

DOI:

https://doi.org/10.15282/jmes.6.2014.28.0098

Keywords:

Car cabin temperature; ventilation mass flow rate; sun exposure; car comfort.

Abstract

In the past few years many fatalities have been reported as the result of internal car heat. Problems arise when the temperature in a car cabin is too hot when parked under direct sunlight. The trapped and accumulated heat causes the temperature inside a car to reach up to 36ºC and even up to 50ºC. The objectives of this paper are to study and analyze the behavior of car cabin temperature influenced by ventilation under direct sun exposure. The performance of the proposed mathematical modelling was compared to data collected in real time from the car cabin. The simulation model was used to study the behavior of cabin temperature by investigating the ventilation mass flow rate as its parameter. An experimental result was obtained from measurements on a salon car parked in the direct sun. It is hoped that this study will be able to provide beneficial information for car interior design and material selection in order to improve comfort levels in cars.

References

Al-Kayiem, H. H., Sidik, M. F., & Munusammy, Y. R. (2010). Study on the thermal accumulation and distribution inside a parked car cabin. American Journal of Applied Sciences, 7(6), 784-789.

Bishop, J., Nedungadi, A., Ostrowski, G., Surampudi, B., Armiroli, P., & Taspinar, E. (2007). An engine start/stop system for improved fuel economy: SAE Technical Paper.

European Parliament. (2009). Setting emission performance standards for new passenger cars as part of the community’s integrated approach to reduce CO2emissions from light-duty vehicles. (Regulation (EC) No. 443/2009 of the European Parliament and of the Council). Official Journal of the European Union.

Fonseca, N., Casanova, J., & Valdés, M. (2011). Influence of the stop/start system on CO2 emissions of a diesel vehicle in urban traffic. Transportation Research Part D: Transport and Environment, 16(2), 194-200.

Grundstein, A., Dowd, J., & Meentemeyer, V. (2010). Quantifying the Heat-Related Hazard for Children in Motor Vehicles. Bulletin of the American Meteorological Society, 91(9), 1186-1191.

Grundstein, A., Meentemeyer, V., & Dowd, J. (2009). Maximum vehicle cabin temperatures under different meteorological conditions. International journal of biometeorology, 53(3), 255-261.

Henein, N. A., Taraza, D., Chalhoub, N., Lai, M.-C., & Bryzik, W. (2000). Exploration of the contribution of the start/stop transients in HEV operation and emissions: SAE Technical Paper.

Konz, M. (2007). Generic simulation of energy consumption of automobile air conditioning systems. Retrieved from http://hdl.handle.net/10948/129

Manning, R., Ewing, J. (2009). .RACQ Vehicles Technologies. (2009). Temperatures in cars survey. RACQ Vehicles Technologies, 1-21.

Rugh, J. P., Farrington, R. B., & Boettcher, J. A. (2001). The impact of metal-free solar reflective film on vehicle climate control. Paper presented at the SAE Conference Proceedings P.

Rugh, J. P., Hendricks, T. J., & Koram, K. (2001). Effect of solar reflective glazing on Ford Explorer climate control, fuel economy, and emissions. Paper presented at the Proceedings of the International Body Engineering Conference.

Saidur, R., Sattar, M. A., & Masjuki, H. H. (2008). Performance of an improved solar car ventilator. Paper presented at the GMSARN International Conference on Sustainable Development: Issues and Prospects for the GMS.

Son, M., & Park, B.-J. (2010). Proactive stop and start technology for high gas mileage of the used car. Paper presented at the Vehicular Technology Conference Fall (VTC 2010-Fall), 2010 IEEE 72nd.

Theodore, L. B., Adrienne, S. L., Frank, P. I., & David, P. D. (2011). Fundamentals of heat and mass transfer (Vol. 7th ed.). New Jersey: John Wiley & Sons.

Downloads

Published

2014-06-30

How to Cite

[1]
M.S.F. Mansor, U.Z. Abd Rahman, M.S. Zainal Abidin, M.Z. Md Zain, and M.R. Md Yusof, “Variation of Car Cabin Temperature Influenced by Ventilation under Direct Sun Exposure”, J. Mech. Eng. Sci., vol. 6, no. 1, pp. 1014–1023, Jun. 2014.

Issue

Section

Article

Similar Articles

<< < 11 12 13 14 15 16 17 18 19 20 > >> 

You may also start an advanced similarity search for this article.