Parametric analysis on a simple design water reaction turbine for low-head low-flow Pico-hydro generation system

Nurul Ashikin Mohd Rais; M. F. Basar

doi:10.15282/jmes.15.3.2021.13.0657

Authors

N. A. M. Rais Faculty of Electrical and Electronic Engineering Technology, Universiti Teknikal Malaysia Melaka, 76100 Durian Tunggal, Melaka, Malaysia. Phone: +6062701000; Fax: +6062701022
M. F. Basar Faculty of Electrical and Electronic Engineering Technology, Universiti Teknikal Malaysia Melaka, 76100 Durian Tunggal, Melaka, Malaysia. Phone: +6062701000; Fax: +6062701022

DOI:

https://doi.org/10.15282/jmes.15.3.2021.13.0657

Keywords:

Low head, low flow, parametric, pico-hydro, reaction turbine, Z-Blade

Abstract

This paper presents a parametric analysis of the outward flow reaction type turbine known as a Z-Blade turbine for low-head low-flow conditions. By applying the principles of mass conservation, momentum and energy, a nomogram was designed to investigate the theoretical performance characteristics. Based on the parametric analysis and the governing equations and experimental results, attempts have been made to prove that the mass flow rate, angular speed, centrifugal head, power output and efficiency respond dynamically to the water head, radius of the rotor, size of the PVC pipes and the nozzle exit area. A turbine with a 1” pipe diameter gives a higher performance compared to a ¹/₂” pipe diameter, and certainly the performances of both pipe sizes are improved when the supplied potential energy is increased. This innovative turbine has a maximum rotational speed at an optimum turbine diameter at 0.6m, accompanied by a point where there is a sudden reduction in the water flow rate, where previously the increment in the water flow rate was very high. This can shows from the outcome nomogram with 1” pipe diameter can perform 350 rpm speed with 1.48 L/sec water flow. The Z-Blade turbine has been examined and has shown good potential to be used for low-head (3m, 4m and 5m) and low-flow (less than 2.5 L/sec) conditions.

References

I. Safdar, S. Sultan, H. A. Raza, M. Umer, and M. Ali, “Empirical analysis of turbine and generator efficiency of a pico hydro system,” Sustain. Energy Technol. Assessments, vol. 37, no. August 2019, p. 100605, 2020, doi: 10.1016/j.seta.2019.100605.

B. N. Fortaleza, R. O. Serfa Juan, and L. K. S. Tolentino, “IoT-based pico-hydro power generation system using pelton turbine,” J. Telecommun. Electron. Comput. Eng., vol. 10, no. 1–4, pp. 189–192, 2018.

A. Lahimer et. al, “Research and development aspects of pico-hydro power,” Renewable and Sustainable Energy Reviews, vol. 16, no. 8, pp. 5861-5878, 2012.

S. J. Williamson, B. H. Stark, and J. D. Booker, “Low head pico hydro turbine selection using a multi-criteria analysis,” Renew. Energy, vol. 61, pp. 43–50, Jan. 2014, doi: 10.1016/j.renene.2012.06.020.

K. Kusakana, “A survey of innovative technologies increasing the viability of micro-hydropower as a cost effective rural electrification option in South Africa,” Renew. Sustain. Energy Rev., vol. 37, pp. 370–379, 2014, doi: 10.1016/j.rser.2014.05.026.

A. Date, A. Date, and A. Akbarzadeh, “Investigating the potential for using a simple water reaction turbine for power production from low head hydro resources,” Energy Conversion and Management, vol. 66. pp. 257–270, 2013, doi: 10.1016/j.enconman.2012.09.032.

A. Akbarzadeh, C. Dixon, and P. Johnson, “Parametric analysis of a simple reaction water turbine and its application for power production from low head reservoirs,” Proceedings of the ASME Fluids Engineering Division Summer Meeting, vol. 2. pp. 697–706, 2003.

A. Date, “Low head simple reaction water turbine,” Thesis Sch. Aerosp. Mech. Manuf. Eng. RMIT Univ., no. April, pp. 1–251, 2009.

A. Date and A. Akbarzadeh, “Design and analysis of a split reaction water turbine,” Renew. Energy, vol. 35, no. 9, pp. 1947–1955, 2010, doi: 10.1016/j.renene.2010.01.023.

A. Date and A. Akbarzadeh, “Design and cost analysis of low head simple reaction hydro turbine for remote area power supply,” Renewable Energy, vol. 34, no. 2. pp. 409–415, 2009, doi: 10.1016/j.renene.2008.05.012.