Influence of Ultra Injection Pressure with Dynamic Injection Timing on CRDI Engine Performance Using Simarouba Biodiesel Blends

Authors

  • Srinath Pai Department of Mechanical Engineering, Srinivas School of Engineering, Mangalore, affiliated to Visvesvaraya Technological University Belagaum - 575014, India
  • Abdul Sharief Department of Mechanical Engineering, P. A. College of Engineering &Technology, Mangalore, affiliated to Visvesvaraya Technological University Belagaum– 574153, India
  • Shiva Kumar Department of Mechanical Engineering, Manipal Institute of Technology, Manipal Academy of Higher Education, Manipal - 576104, India

DOI:

https://doi.org/10.15282/ijame.15.4.2018.3.0440

Keywords:

Biodiesel; performance; emission; common rail direct injection (CRDI), engine; injection pressure and timing.

Abstract

A single cylinder diesel engine upgraded to operate Common Rail Direct Injection (CRDI) system and employed in this investigation. Tests were conducted on this engine using High-Speed diesel (HSD) and Simarouba biodiesel (SOME) blends to determine the influence of Injection Pressure (IP) and Injection Timing (IT) on the performance and emissions. Four unique IP of 400 bar to 1000 bar, in steps of 200 bar and four differing ITs of 10°, 13°, 15° and 18° before Top Dead Center (bTDC) combinations were attempted for the 25% to full load. Compression Ratio (CR) of 16.5 and Engine speed of 1500 RPM was kept constant during all trails. Critical performance parameter like Brake Thermal Efficiency (BTE) and Brake Specific Fuel Consumption (BSFC) were analyzed, primary emission parameters of the diesel engine The NOx and Smoke opacity were recorded. Finally, the outcomes of each combination were discussed.

Downloads

Published

2018-12-24

How to Cite

[1]
S. Pai, A. Sharief, and S. Kumar, “Influence of Ultra Injection Pressure with Dynamic Injection Timing on CRDI Engine Performance Using Simarouba Biodiesel Blends”, Int. J. Automot. Mech. Eng., vol. 15, no. 4, pp. 5748–5759, Dec. 2018.

Similar Articles

<< < 30 31 32 33 34 35 36 37 38 39 > >> 

You may also start an advanced similarity search for this article.