Volume 19 No. 3, (September 2025)

Article

• Mesh independence study for an onshore OWC using Richardson's extrapolation: Numerical and analytical analysis

  Juan David Parra Quintero

  10698 - 10712

  • PDF

• Simultaneous humidity and temperature measurement sensor based on coated multiplexed fibre bragg gratings

  Abdur Rahman Azmi, Muhammad Aizzuddin Abdullah, Vorathin Epin, Kok-Sing Lim, Mazian Mohammad, Abdul Rahim Othman, Ahmad Rasdan Ismail

  10713 - 10726

  • PDF

• Assessing the impact resistance and damage tolerance of Aluminium composite fibre metal laminates under low velocity impact test

  Mohd Fadhil Rani, M. R. M. Rejab, N. Ab. Razak, M. I. Ibrahim, M. Z. Azir, Z. Zaulkafilai

  10727 - 10738

  • PDF

• Development of an intelligent jet engine controller using a model-based deep deterministic policy gradient technique

  Esam Mohammad, Mehdi Jahromi, Jamasb Pirkandi, Mostafa Khazaee, Mostafa Mahmoodi

  10739 - 10755

  • PDF

• Optimization of hybrid flow shop scheduling in a machine shop: Achieving energy efficiency and minimizing machine idleness with multi-objective Tiki Taka optimization

  S. N. H. H. M. Hata, M. A. N. Mutasim, M. F. F. Ab. Rashid

  10756 - 10769

  • PDF

• Dynamic and sensitivity analysis of V-shaped cross section piezoelectric beam as mass sensor for high-order vibration modes

  Reza Ghaderi, Hashem Safari

  10770 - 10781

  • PDF

• Influence of isobutanol fuel additive in B40 palm oil methyl ester on engine performance of a diesel engine

  Najmi Haziq Badrulhisam, Omar Malek Abbas, Muhammad Yusri Ismail, Abdul Adam Abdullah

  10782 - 10790

  • PDF

• Optimization of exoskeleton design for post-stroke ankle rehabilitation based on kinematic and structural model evaluation

  Eko Wahyu Abryandoko, Faisal Ashari

  10791 - 10804

  • PDF

• Development of laser cleaning state classification model through the acquired acoustic signal using the empirical mode decomposition and one dimensional convolutional neural network

  M. F. M. Yusof, S. A. A. Aleem, M. A. M. Halim, M. Ishak

  10805 - 10816

  • PDF

• Optimized manufacturing and temperature-dependent structural and property analysis of multi-phase functionally graded materials

  K. Sainath, R. Karuppasamy, S. Prabagaran

  10817 - 10831

  • PDF