Vol. 1 (2011): December 2011

Published: 2011-12-01

Article

Prediction of Surface Roughness of Ti-6Al-4V in Electrical Discharge Machining: A Regression Model

Md. Ashikur Rahman Khan, M.M. Rahman, K. Kadirgama, M.A. Maleque, M. Ishak

16-24
- PDF
A study on the Potential of Cost and Energy - A Survey At playford building, University of South Australia

J. Ramli, Y. Nor Imrah, A.R. Jeefferie, M.M. Mahat

25-36
- PDF
Finite Element Analysis of HASTELLOY C-22HS in End Milling

K. Kadirgama, M.M. Rahman, A.R. Ismail, R.A. Bakar

37-46
- PDF
Simulation Study of Cutting Tool System using Intelligent Active Force Control

M.M. Hatifi, M.F. Hassan, A.R. Yusoff

62-74
- PDF
Aerodynamic Studies in the Static Components of A Centrifugal Compressor Stage

K. Srinivasa Reddy, G.V. Ramana Murty, K.V. Sharma

75-86
- PDF
Performance Evaluation of External Mixture Formation Strategy in Hydrogen Fueled Engine

Mohammed Kamil, M. M. Rahman, Rosli A. Bakar

87-98
- PDF
An Experimental Study on Heat Transfer and Friction Factor of Al2O3 Nanofluid

L. Syam Sundar, K.V. Sharma

99-112
- PDF
Reduction of Oil Contamination on Hard Disk Drive Parts using Automatic Hydrocarbon Washing Machine

Somkiat Tangjitsitcharoen, Nuntawat Nunya

113-123
- PDF
Experimental Analysis of Heat And Mass Transfer In a Packed Bed

K.V. Suryanarayana, G. Srinivasa Rao, D.M. Reddy Prasad, K.V. Sharma, P.K. Sarma

124-132
- PDF

Review

Literature Review of Optimization Technique for Chatter Suppression in Machining

Ahmad Razlan Yusoff, Mohamed Reza Zalani Mohamed Suffian, Mohd Yusof Taib

47-61
- PDF