Experimental investigation of two-phase separation in a horizontal T-junction with vertical branch arm

Authors

  • Z. Q. Memon Department of Mechanical Engineering, Universiti Teknologi PETRONAS, 32610 Seri Iskandar, Perak, Malaysia
  • W. Pao Department of Mechanical Engineering, Universiti Teknologi PETRONAS, 32610 Seri Iskandar, Perak, Malaysia.
  • F. Hashim Department of Mechanical Engineering, Universiti Teknologi PETRONAS, 32610 Seri Iskandar, Perak, Malaysia
  • S. Ahmed Department of Education, Sukkur IBA University, Airport Road Sukkur, Sindh Pakistan

DOI:

https://doi.org/10.15282/jmes.13.4.2019.14.0470

Keywords:

Gas-liquid separation; T-junction; slug flow; diameter ratio effect; superficial phases’ velocities., Gas-liquid separation, T-junction, slug flow, diameter ratio effect, superficial phases’ velocities

Abstract

T-junctions are commonly used in offshore platforms and process industry. When two-phase flow passes through T-junction, separation of two-phases takes place. This separation of two-phase flow through T-junction produces high liquid carry-over in the branch arm, causing breakdown of downstream equipment. In this experimental study, phase separation data have been obtained for air-water mixture flow through dividing T-junction with a pipe diameter of 74 mm and the branch arm is positioned vertically upward. T-junctions with diameter ratios of 1, 0.67, 0.5, and 0.27 were tested in the slug flow regime. The superficial velocities of air (JG1) were varied 0.20 - 1.16 m/s and inlet water superficial velocities (JL1) were varied 0.40-0.53 m/s. The extraction ratio between branch arm and main arm (W3/W1) was varied between 0 to 1. It was observed that the phase separation efficiency of T-junction depends upon the diameter ratio, upstream superficial velocities of both phases - air and water. Finally, the experimental data have been compared against the predicted results obtained from the numerical correlations.

References

Memon ZQ, Pao W, Hashim F, Ahmed S. Experimental investigation of multiphase separation in different flow regimes through T-junction with an expander section. Journal of Mechanical Engineering and Sciences. 2019;13: 5163–5181.

Saieed A, Pao W, Hashim, F.M. Effect of T-junction diameter ratio on stratified-wavy flow separation. Journal of Natural Gas Science and Engineering. 2018;51:223–232.

Sam B, Pao W, Nasif MS, Norpiah RBM. Simulation of two phase oil-gas flow in T-junction. ARPN Journal of Engineering and Applied Sciences. 2016;11:12011–12016.

Memon ZQ, Tran CM, Pao W, Hashim FM. Two-phase slug flow separation at T-junction with regular and reduced vertical side arm. In AIP Conference Proceedings: AIP Publishing; 2018.

Saieed A, Pao W, Hewakandamby B, Azzopardi BJ, Wood DA, Ali HM. Experimental investigation on the effect of diameter ratio on two-phase slug flow separation in a T-Junction. Journal of Petroleum Science and Engineering. 2018;170:139–150.

Wren E, Baker G, Azzopardi BJ, Jones R. Slug flow in small diameter pipes and T-junctions. Experimental Thermal and Fluid Science. 2005;29:893–899.

Saieed A, Pao W, Ali HM. Prediction of phase separation in a T-Junction. Experimental Thermal and Fluid Science. 2018;97:160–179.

Tran M, Memon Z, Saieed A, Pao W, Hashim F. Numerical simulation of two-phase separation in T-junction with experimental validation. Journal of Mechanical Engineering and Sciences. 2018;12:4216–4230.

Chen J, Wang S, Cheng S. Experimental investigation of two-phase distribution in parallel micro-T channels under adiabatic condition. Chemical Engineering Science. 2012; 84:706–717.

Wren E. Geometric effects on phase split at a large diameter T-junction. Ph.D. dissertation, University of Nottingham, Nottingham, UK; 2001.

Das G, Das PK, Azzopardi BJ. The split of stratified gas-liquid flow at a small diameter T-junction. International Journal of Multiphase Flow 2005;31:514–528.

Pao W, Hashim FM, Ming LH. Numerical investigation of gas separation in T-junction. In AIP Conference Proceedings: AIP Publishing; 2015.

Tran M, Memon Z, Pao W, Hashim FM. Preliminary Results of Numerical Simulation of Slug Flow in a Regular T-Junction. In MATEC Web of Conferences 2018.

Azzopardi BJ, Colman DA, Nicholson D. Plant application of a T-junction as a partial phase separator. Chemical Engineering Research and Design. 2002;80:87–96.

Azzopardi BJ. The effect of side arm diameter on phase split at T-junctions. In: SPE Annual Technical Conference and Exhibition; 1999.

Peng F. A study of dividing two phase flow in horizontal inlet T-junction, Ph.D. dissertation, McMaster University, Hamilton, Ontario, Canada, 1994.

Baker G. Separation and control of gas-liquid flows at horizontal T-junctions, Ph.D. dissertation, University of Nottingham, UK, 2003.

Pao W, Sam B, Saieed A, Tran CM. Numerical investigation of liquid carryover in T-Junction with different diameter ratios. In IOP Conference Series: Materials Science and Engineering; 2018.

Shoham O, Arirachakaran S, P.Brill, J., Two-phase Flow Splitting in horizontal reduced pipe tee. Chemical Engineering Science. 1989;44:2388–2391.

Walters LC. Two-phase pressure drop and phase distribution at horizontal tee junction: the effect of branch diameter, Ph.D. dissertation, University of Manitoba Winnipeg, Manitoba, 1994.

Yang L, Wang J, Zhao Z, Xu S, et al. Phase separation of gas-liquid two-phase stratified and plug flows in multitube T-junction separators. AIChE Journal 2017;63:2285–2292.

Rubel MT, Soliman HM, Sims GE. Phase distribution during steam-water flow in a horizontal T-junction. International Journal of Multiphase Flow. 1988;14:425–438.

Reimann J, Brinkmann HJ, Domanski R. Gas-liquid flow in dividing Tee-Junctions with a horizontal Inlet and different branch orientations and diameters, MS dissertation, Technical University of Warsaw, Poland, 1988.

Ballyk JD, Shoukri M. On the development of a model for predicting phase separation phenomena in dividing two-phase flow. Nuclear Engineering and Design. 1990;123:67–75.

Buel JR, Soliman HM, Sims GE, Two-phase pressure drop and phase distribution of a horizontal tee junction. International Journal of Multiphase Flow. 1994;20:819–836.

Saieed A. Experimental investigation on the effect of diameter ratio on two-phase separation in a T-junction, MSc dissertation, Universiti Teknologi Petronas (UTP) Malaysia, 2017.

Taitel Y, Dukler AE. A model for predicting flow regime transitions in horizontal and near horizontal gas-liquid flow. AICHE Journal 1976;22:47–55.

Wren E, Azzopardi BJ. The Phase separation capabilities of two T-junctions placed in series. Chemical Engineering Research and Design. 2004;82:364–371.

Walters LC, Soliman HM, Sims GE. Two-phase pressure drop and phase distribution at reduced tee junction. International Journal of Multiphase Flow. 1994;20:819–836.

Arirachakaran S. Two-phase slug flow splitting phenomenon at a regular horizontal side-arm tee, Ph.D. dissertation, University of Tulsa, Tulsa USA, 1990.

Downloads

Published

2019-12-30

How to Cite

[1]
Z. Q. Memon, W. Pao, F. Hashim, and S. Ahmed, “Experimental investigation of two-phase separation in a horizontal T-junction with vertical branch arm”, J. Mech. Eng. Sci., vol. 13, no. 4, pp. 5922–5937, Dec. 2019.

Similar Articles

<< < 2 3 4 5 6 7 8 9 10 11 > >> 

You may also start an advanced similarity search for this article.