Performance analysis of 110 MW steam power plant with solar aided reheating system using GateCycle software

Authors

  • Eflita Yohana Department of Mechanical Engineering, Diponegoro University, Jl. Prof. Soedarto, S.H., Semarang, Indonesia
  • Mohamad Utomo Department of Mechanical Engineering, Diponegoro University, Jl. Prof. Soedarto, S.H., Semarang, Indonesia
  • Kholid Azis Department of Mechanical Engineering, Diponegoro University, Jl. Prof. Soedarto, S.H., Semarang, Indonesia
  • Achmad Afinadi Department of Mechanical Engineering, Diponegoro University, Jl. Prof. Soedarto, S.H., Semarang, Indonesia
  • Mohammad Dwinanda Department of Energy Conservation & Loss Control, Engineering Development, Ref. Unit V Balikpapan, Indonesia
  • Mohamad Yulianto Department of Chemical Engineering Vocational School, Diponegoro University, Jl. Prof. Soedarto, S.H., Semarang, Indonesia

DOI:

https://doi.org/10.15282/gk4vq470

Keywords:

Steam power plant, Reheating, Solar collector, Direct Normal Irradiance, GateCycle

Abstract

Along with the world's rapid population growth, the demand for electrical energy is also increasing. Hence, it is necessary to take innovative and environmentally friendly steps toward existing power plants to overcome the issue. One is using a solar-aided reheating system implemented in a steam power plant to increase its performance. In this study, an analysis of the reheating system with a solar collector was carried out on a particular steam power plant for the same loadings. The conditions of the Direct Normal Irradiance (DNI) at the location where the steam power plant was established were also considered in this study. A mathematical analysis was carried out to calculate the increase in thermal oil temperature heated by the solar collector with several different conditions throughout the year. The results were in the form of thermal oil outlet temperatures, which were then used as input for the simulation of a steam power plant that was assumed to be integrated with the solar-aided reheating system using GateCycle software. It was found that the performance of the steam power plant worked better when using a solar-aided reheating system compared to those without the solar system. At 100%, 75%, and 50% loading, power increased by 4.51% to 5.86%, 6.18% to 8.18%, and 8.91% to 11.42%, respectively. The highest performance increase occurred in March, and the lowest occurred in January due to the level of DNI in both months.

References

[1] Directorate General of Electricity of the Ministry of Energy and Mineral Resources 2020 Materials of the Directorate General of Electricity Press Conference Performance Achievements of the Electricity Subsector p 21.

[2] Central Bureau of Statistics 2019 Official news statistics (BpsGoId) pp 1–52.

[3] Abdulhamed A J, Adam N M, Ab-Kadir M Z A and Hairuddin A A 2018 Review of solar parabolic-trough collector geometrical and thermal analyses, performance, and applications. Renew. Sustain. Energy Rev. 91 822–31

[4] Huichao X, Chao Y, Srinivasan D, Rangaiah G P, Poh T K 2016 Modelling and validation of parameters of combined cycle power plant. Int. Conf. on Power Syst Technol. (POWERCON 2016).

[5] Oyedepo S O et al 2020 Dataset on thermodynamics performance analysis and optimization of a reheat – regenerative steam turbine power plant with feed water heaters. Data. Br. 32 106086

[6] Bellos E, Tzivanidis C and Tsimpoukis D 2018 Enhancing the performance of parabolic trough collectors using nanofluids and turbulators. Renew. Sustain. Energy Rev. 91 358–75

[7] Bai Z, Sun J and Liu Q 2018 Comprehensive assessment of line-/point-focus combined scheme for concentrating solar power system. Int. J. Energy Res. 42 1983–98

[8] Bellos E and Tzivanidis C 2018 Analytical expression of parabolic trough solar collector performance. Designs 2 1–17

[9] Bellos E, Tzivanidis C and Belessiotis V 2017 Daily performance of parabolic trough solar collectors. Sol. Energy 158 663–78

[10] Bishoyi D and Sudhakar K 2017 Modeling and performance simulation of 100 MW PTC based solar thermal power plant in Udaipur India. Case Stud. Therm. Eng. 10 216–26.

[11] Qu W, Wang R, Hong H, Sun J and Jin H 2017 Test of a solar parabolic trough collector with rotatable axis tracking. Appl. Energy 207 7–17

[12] Pavlovic S, Bellos E and Loni R 2018 Exergetic investigation of a solar dish collector with smooth and corrugated spiral absorber operating with various nanofluids. J. Clean Prod. 174 1147–60

[13] Indonesian Metrology, Climatology and GC 2021 Riau Air Quality Index (Riau)

[14] Vural G 2020 How do output, trade, renewable energy and non-renewable energy impact carbon emissions in selected Sub-Saharan African Countries? Resour. Policy 69 101840

[15] Vohra K, Vodonos A, Schwartz J, Marais E A, Sulprizio M P and Mickley L J 2021 Global mortality from outdoor fine particle pollution generated by fossil fuel combustion: Results from GEOS-Chem. Environ. Res. 195 110754

[16] Li L et al 2021 Review and outlook on the international renewable energy development. Energy Built Environ.

[17] Suman A 2021 Role of renewable energy technologies in climate change adaptation and mitigation: A brief review from Nepal. Renew. Sustain. Energy Rev. 151 111524

[18] Zheng H, Song M and Shen Z 2021 The evolution of renewable energy and its impact on carbon reduction in China. Energy 237 121639

[19] Yuping L et al 2021 Determinants of carbon emissions in Argentina: The roles of renewable energy consumption and globalization. Energy Reports 7 4747–60

[20] Srinivas T, Gupta A V S S K S and Reddy B V 2007 Generalized thermodynamic analysis of steam power cycles with "n" number of feedwater heaters. Int. J. Thermodyn. 10 177–85

[21] Toledo M, Abugaber J, Lugo R, Salazar M, Rodríguez A and Rueda A 2014 Energetic analysis of two thermal power plants with six and seven heaters. Open J. Appl. Sci. 04 6–12

[22] Wang D, Li H, Wang C, Zhou Y, Li X and Yang M 2021 Thermodynamic analysis of coal-fired power plant based on the feedwater heater drainage-air preheating system. Appl. Therm. Eng. 185 116420

[23] Fu C, Anantharaman R and Gundersen T 2015 Optimal integration of compression heat with regenerative steam Rankine cycles in oxy-combustion coal based power plants. Energy 84 612–22

[24] Chen Z, Wang Y and Zhang X 2020 Energy and exergy analyses of S–CO2 coal-fired power plant with reheating processes. Energy 211 118651

[25] Chen H, Wu Y, Zeng Y, Xu G and Liu W 2021 Performance analysis of a solar-aided waste-to-energy system based on steam reheating. Appl. Therm. Eng. 185 116445

[26] Liu H, Zhai R, Patchigolla K, Turner P and Yang Y 2021 Off-design thermodynamic performances of a combined solar tower and parabolic trough aided coal-fired power plant. Appl. Therm. Eng. 183 116199

[27] Dalvi VH, Panse S V and Joshi J B 2015 Solar thermal technologies as a bridge from fossil fuels to renewables. Nat. Clim. Chang. 5 1007–13

[28] Ahmadi G, Toghraie D and Akbari O A 2017 Solar parallel feed water heating repowering of a steam power plant: A case study in Iran. Renew. Sustain. Energy Rev. 77 474–85

[29] Li X, Xu E, Ma L, Song S and Xu L 2019 Modeling and dynamic simulation of a steam generation system for a parabolic trough solar power plant. Renew. Energy 132 998–1017

[30] Wang K, et al 2020 Highly-efficient nanofluid-based direct absorption solar collector enhanced by reverse-irradiation for medium temperature applications. Renew. Energy 159 652–62

[31] Malinowski L, Lewandowska M and Giannetti F 2018 Design and analysis of a new configuration of secondary circuit of the EU-DEMO fusion power plant using GateCycle. Fusion. Eng. Dec. 136 1149–52

[32] Kotowicz J, Łukowicz H, Bartela Ł and Michalski S 2011 Validation of a program for supercritical power plant calculations. Arch. Thermodyn. 32 81–9

[33] Riau Power Plant Performance Test Report 2017

[34] World Bank Group 2017 Solar Resource and Photovoltaic Potential of Indonesia

[35] Alotaibi S, Alotaibi F and Ibrahim O M 2020 Solar-assisted steam power plant retrofitted with regenerative system using Parabolic Trough Solar Collectors. Energy Reports 6 124–33

[36] Okonkwo E C, Essien E A, Akhayere E, Abid M, Kavaz D and Ratlamwala T A H 2018 Thermal performance analysis of a parabolic trough collector using water-based green-synthesized nanofluids. Sol. Energy 170 658–70

[37] Bellos E, Tzivanidis C and Antonopoulos K A 2017 A detailed working fluid investigation for solar parabolic trough collectors. Appl. Therm. Eng. 114 374–86

[38] Geyer M and Lüpfert E 2002 Eurotrough - Parabolic Trough Collector Developed for Cost Efficient Solar Power Generation pp 1–7.

[39] Eastman 2020 Therminol VP-1 (Technical Bulletin TF9141).

Downloads

Published

30-03-2025

Issue

Section

Articles

How to Cite

[1]
E. Yohana, M. Utomo, K. Azis, A. Afinadi, M. Dwinanda, and M. Yulianto, “Performance analysis of 110 MW steam power plant with solar aided reheating system using GateCycle software”, JMMST, vol. 9, no. 1, pp. 5–12, Mar. 2025, doi: 10.15282/gk4vq470.

Similar Articles

1-10 of 21

You may also start an advanced similarity search for this article.