Vol. 17 No. 3 (2020): July-September

View Vol. 17 No. 3 (2020): July-September

Published: 2020-10-07

Articles

Models for Machining Accuracy in Multi-Tool Adjustment

N.D. Yusubov, H.M. Abbasova

8067-8085
- PDF
Fatigue Crack Growth and Fracture Toughness in a Dual Phase Steel: Effect of Increasing Martensite Volume Fraction

C. Perez Velasquez, D. Avendano Rodriguez, C. Narvaez Tovar, L. Mujica Roncery, R. Rodríguez Baracaldo

8086-8095
- PDF
Composite Failure Modes at High Cyclic Fatigue Life Evaluation

Haider F. Al-Qrimli, Mustafa J. Al-Dulaimi, Kayser A. Ameen

8096-8103
- PDF
A Novel Way to Overcome Problems Arising in Strain Signal Measurements Leading to a Fatigue Failure Characterisation

T.E. Putra, S. Abdullah, D. Schramm

8104-8115
- PDF
Development of Reinforced Extension Type Flexible Pneumatic Actuator with Circumferential Restraints and Its Application for Rehabilitation Device

S. Shimooka, T. Akagi, S. Dohta, T. Shinohara, M. Aliff

8116-8127
- PDF
Performance Analysis on Eco-friendly Machining of Ti6Al4V using Powder Mixed with Different Dielectrics in WEDM

S. Chakraborty, S. Mitra, D. Bose

8128-8139
- PDF
An Investigation on Surfactant Added PMWEDM of Inconel 718

A. Ranjan, S. Chakraborty, D. Kumar, D. Bose

8140-8149
- PDF
Microstructural and Mechanical Behaviour Evaluation of Mg-Al-Zn Alloy Friction Stir Welded Joint

Kulwant Singh, Gurbhinder Singh, Harmeet Singh

8150-8159
- PDF
Squeal Noise Analysis Using A Combination of Nonlinear Friction Contact Model

M. Rusli, M.H. Fesa, H. Dahlan, M. Bur

8160-8167
- PDF
Influence of Pin Offset and Weave Pattern on the Performance of Al-Cu Joints Reinforced with Graphene Particles

M. Balasubramanian, D. Jayabalakrishnan

8186-8196
- PDF
The Influence of Non-Pneumatic Tyre Structure on its Operational Properties

Z. Hryciów, J. Jackowski, M. Żmuda

8168-8178
- PDF
Tuft Flow Visualisation on UTM-LST VFE-2 Delta Wing Model Configuration at High Angle of Attacks

M. Said, M. Imai, S. Mat, M. N. Dahalan, S. Mansor, M. N. Mohd Nasir, N. A. R. Nik Mohd

8214-8223
- PDF
Effect of Silver Content on the Crystalline Phase and Microstructure of TiO2 Coating Deposited on Unglazed Ceramics Tile

N.Z. Hafizah, J. M. Juoi, M.R. Zulkifli, M.A. Musa

8179-8185
- PDF
Role of Aluminium on the Microstructure and Corrosion Behaviour of Magnesium Prepared by Powder Metallurgy Method

J. Alias

8206-8213
- PDF
Ergonomics Study Among Operators in Water-Jet Production Area in Aircraft Industry

W.N.F. W. Mahmod, U. N. N. Abdullah, N. Othman

8197–8205
- PDF
An Experimental Investigation on Thermal Conductivity and Viscosity of Graphene doped CNTs /TiO2 Nanofluid

A.M. Zetty Akhtar, M.M. Rahman, K. Kadirgama, M.A. Maleque

8224–8233
- PDF