Optimization of neem biodiesel blends and hydrogen addition to improve compression ignition engine performance

D S Doifode; A J Keche

doi:10.15282/ijame.23.1.2026.5.1003

Authors

D S Doifode Mechanical Engineering Department, Maharashtra Institute of Technology, Aurangabad, 431010 Maharashtra, India https://orcid.org/0009-0002-7107-7753 (unauthenticated)
A J Keche Mechanical Engineering Department, Maharashtra Institute of Technology, Aurangabad, 431010 Maharashtra, India https://orcid.org/0000-0003-4405-4388 (unauthenticated)

DOI:

https://doi.org/10.15282/ijame.23.1.2026.5.1003

Keywords:

Neem seed oil, Biodiesel, Hydrogen energy, CI engine, ANN

Abstract

This research investigates the effects of Neem biodiesel and hydrogen-enriched air on the emissions and performance of a common-rail direct-injection diesel engine operating under variable load conditions of 25%, 50%, 75%, and 100%. The aim is to improve engine efficiency and promote sustainable energy solutions. Several Neem biodiesel blends (B10-B30) were initially evaluated, and B15 was selected for comprehensive analysis due to its optimal performance. Hydrogen as a gaseous fuel was subsequently inducted into the inlet air at rates of 3.34 to 9.27 liters per minute to assess its influence on engine behavior. Key parameters, including Brake Thermal Efficiency (BTE), Brake Specific Fuel Consumption (BSFC), and emissions of carbon monoxide (CO), hydrocarbons (HC), and oxides of nitrogen (NOx), were analyzed. The B15 blend exhibited a BSFC of 0.27 kg/kWh and a BTE of 31.38% at full load. With hydrogen supplementation at 5.19 liters per minute, BTE increased to 33.31%, and BSFC decreased to 0.25 kg/kWh. NOx and CO emissions were reduced to 488 ppm and 0.04%, respectively, while HC emissions remained unchanged. Hydrogen’s high flame speed and broad flammability range contributed to emission reductions; however, higher hydrogen levels led to higher NOx emissions, necessitating ongoing monitoring to comply with regulations. The artificial neural network model, trained on experimental data, was very good at predicting performance and emissions, suggesting it could be used for real-time combustion diagnostics and fuel optimization. In summary, adopting dual-fuel systems utilizing hydrogen and Neem biodiesel offers significant potential to reduce the environmental impact of diesel engines.

References

[1] K. Maniyar, G. Kale, A. Salunke, A. Salunke, R. Marode, P. Jadhav, et al., “Comparative study of hybrid vehicles with traditional vehicles,” in Green Technology and Smart Materials for Engineering Applications, CRC Press, 2025, pp. 385–396.

[2] S. Sayyed, R.K. Das, K. Kulkarni, “Experimental investigation for evaluating the performance and emission characteristics of DICI engine fueled with dual biodiesel-diesel blends of Jatropha, Karanja, Mahua, and Neem,” Energy, vol. 238, p. 121787, 2022.

[3] E. Elnajjar, S.A.B. Al-Omari, M.Y.E. Selim, S.T.P. Purayil, “CI engine performance and emissions with waste cooking oil biodiesel boosted with hydrogen supplement under different load and engine parameters,” Alexandria Engineering Journal, vol. 61, no. 6, pp. 4793–4805, 2022.

[4] A. Loyte, J. Suryawanshi, S.S.K. Bellala, R.V. Marode, Y. Devarajan, “Current status and obstacles in the sustainable synthesis of biohydrogen from microalgal species,” Results in Engineering, vol. 24, p. 103455, 2024.

[5] M.H. Ali, M. Mashud, M.R. Rubel, R.H. Ahmad, “Biodiesel from Neem oil as an alternative fuel for diesel engine,” in Procedia Engineering, vol. 56, pp. 625–630, 2013.

[6] M. Takase, T. Zhao, M. Zhang, Y. Chen, H. Liu, L. Yang, et al., “An expatiate review of neem, jatropha, rubber and karanja as multipurpose non-edible biodiesel resources and comparison of their fuel, engine and emission properties,” Renewable and Sustainable Energy Reviews, vol. 43, pp. 495-520, 2015.

[7] B.A. Oni, D. Oluwatosin, “Emission characteristics and performance of neem seed (Azadirachta indica) and Camelina (Camelina sativa) based biodiesel in diesel engine,” Renewable Energy, vol. 149, pp. 725–734, 2020.

[8] D.Y. Dhande, S. J. Navale, “Experimental investigations on the performance and emissions of compression ignition engine fuelled with lower blends of neem-based biodiesel,” Archives of Automotive Engineering, vol. 103, no. 1, pp. 57–76, 2024.

[9] M. Mathiyazhagan, K. Meenakshi Sundaram, G. Bupesh, “Production and emission evaluation of neem biodiesel blends in a single cylinder diesel engine,” in Materials Today: Proceedings, vol. 62, pp. 2124-2132, 2022.

[10] S. Senthil, N. Poyyamozhi, R. Sathiyamoorthi, N. Dilip Raja, M. Muthukannan, “Experimental analysis of hemispherical combustion geometry of diesel engine (neem oil) biodiesel with nano additives,” Interactions, vol. 245, no. 1, p. 258, 2024.

[11] M.M. Khan, A.K. Kadian, R.P. Sharma, S.M.M. Hasnain, A. Mohamed, A.E. Ragab, et al., “Emission reduction and performance enhancement of CI engine propelled by Neem biodiesel-Neem oil-decanol-diesel blends at high injection pressure,” Sustainability, vol. 15, no. 11, p. 9084, 2023.

[12] S.S. Halewadimath, N.R. Banapurmath, V.S. Yaliwal, M.G. Prasad, S.S. Jalihal, M E.M. Soudagar, et al., “Effect of manifold injection of hydrogen gas in producer gas and neem biodiesel fueled CRDI dual fuel engine,” International Journal of Hydrogen Energy, vol. 47, no. 62, pp. 25913–25928, 2022.

[13] N. Khan, B. Balunaik, S. Yousufuddin, “Performance and emission characteristics of a diesel engine with varying injection pressure and fueled with hydrogen and cottonseed oil methyl ester blends,” Materials Today: Proceedings, vol. 5, no. 2, pp. 3369–3377, 2018.

[14] K. Ramalingam, E.P. Venkatesan, S. Vellaiyan, A. Mukhtar, M. Sharifpur, A.S.H. Md Yasir, et al., “Substitution of diesel fuel in conventional compression ignition engine with waste biomass-based fuel and its validation using artificial neural networks,” Process Safety and Environmental Protection, vol. 177, pp. 1234–1248, 2023.

[15] S. Javed, Y.V.V. Satyanarayana Murthy, R.U. Baig, D. Prasada Rao, “Development of ANN model for prediction of performance and emission characteristics of hydrogen dual-fueled diesel engine with Jatropha Methyl Ester biodiesel blends,” Journal of Natural Gas Science and Engineering, vol. 26, pp. 549–557, 2015.

[16] H. Dave, V. Vakharia, H. Panchal, M. I. H. Siddiqui, D. Dobrota, “ANN and Multilayer-ELM based prediction of combustion, performance and emission characteristics of a diesel engine fuelled with Diesel-DTBP blends,” Case Studies in Thermal Engineering, vol. 72, p. 1063232025.

[17] T. Sathish, V. Mohanavel, M. Arunkumar, K. Rajan, M.E.M. Soudagar, M.A. Mujtaba, et al., “Utilization of Azadirachta indica biodiesel, ethanol and diesel blends for diesel engine applications with engine emission profile,” Fuel, vol. 319, p. 123798, 2022.

[18] D. Sakthivadivel, P.G. Kumar, R. Prabakaran, V.S. Vigneswaran, K. Nithyanandhan, S.C. Kim, “A neem oil-based biodiesel with DEE-enriched ethanol and Al2O3nano additive: An experimental investigation on the diesel engine performance,” Case Studies in Thermal Engineering, vol. 34, p. 102021, 2022.

[19] N. Khan, M. Sohail, N. Raja Srikanth, S. Azam Pasha Quadri, “Performance testing on IC engine using diesel mixed with neem castor oil,” International Journal of Engineering Research and Applications, vol. 11, pp. 41–46, 2021.

[20] J.N. Nair, A.K. Kaviti, A.K. Daram, “Analysis of performance and emission on compression ignition engine fuelled with blends of Neem biodiesel,” Egyptian Journal of Petroleum, vol. 26, no. 4, pp. 927–931, 2017.

[21] A.M. Abdullah, “Combined impact of hydrogen fuel, nitrogen, and EGR with waste spent lubricant oil blended diesel on common rail direct injection diesel engine under varying loads,” Journal of Umm Al-Qura University for Engineering and Architecture, vol. 16, no. 4, pp. 911-922, 2025.

[22] V. Thanigaivelan, M. Loganathan, M. Vikneswaran, S. Venkatramanan, M. Manickam, “Effect of hydrogen and ethanol addition in cashew nut shell liquid biodiesel operated direct injection (DI) diesel engine,” International Journal of Hydrogen Energy, vol. 47, no. 8, pp. 5111–5129, 2022.

[23] S. Ramalingam, M. DhakshinaMoorthy, S. Subramanian, “Effect of natural antioxidant additive on hydrogen-enriched biodiesel operated compression ignition engine,” International Journal of Hydrogen Energy, vol. 47, no. 48, pp. 20771–20783, 2022.

[24] J. Paparao, S. Murugan, “Dual-fuel diesel engine run with injected pilot biodiesel-diesel fuel blend with inducted oxy-hydrogen (HHO) gas,” International Journal of Hydrogen Energy, vol. 47, no. 40, pp. 17788–17807, 2022.

[25] M. Loganathan, V.M. Madhavan, K. Arun Balasubramanian, V. Thanigaivelan, M. Vikneswaran, A. Anbarasu, “Investigation on the effect of diethyl ether with hydrogen-enriched cashew nut shell (CNS) biodiesel in direct injection (DI) diesel engine,” Fuel, vol. 277, p. 118165, 2020.

[26] M. Parthasarathy, J. Isaac JoshuaRamesh Lalvani, B. Dhinesh, K. Annamalai, “Effect of hydrogen on ethanol–biodiesel blend on performance and emission characteristics of a direct injection diesel engine,” Ecotoxicol Environ Saf, vol. 134, pp. 433–439, 2016.

[27] M.M.K. Bhuiya, M.G. Rasul, M.M.K. Khan, N. Ashwath, A.K. Azad, M.A. Hazrat, “Second generation biodiesel: Potential alternative to edible oil-derived biodiesel,” Energy Procedia, vol. 61, pp. 1969–1972, 2014.

[28] S.K. Dash, P.V. Elumalai, P.S. Ranjit, P.K. Das, R. Kumar, S. Kunar, et al., “Experimental investigation on synthesis of biodiesel from non-edible Neem seed oil: Production optimization and evaluation of fuel properties,” Materials Today: Proceedings, vol. 47, pp. 2463–2466, 2021.

[29] P.M. Kadam, D.R. Dolas, S. Pal, S.S. Gajghate, “Impact of soybean biodiesel blends with mixed graphene nanoparticles on compression ignition engine performance and emission: An experimental and ANN analysis,” International Journal of Automotive and Mechanical Engineering, vol. 21, no. 3, pp. 11512–11525, 2024.

[30] J. Nursyairah, H.L.N. Lau, R.I.A. Jalal, “Evaluation of Operability and Exhaust Emissions of Common Rail Direct Injection Engine using Biodiesel Blends in Moderate Cold Environment,” International Journal of Automotive and Mechanical Engineering, vol. 21, no. 4, pp. 11893–11908, 2024.