Unsteady Drag Analysis of Platoon Vehicles using Unsteady Reynolds-Averaged Navier-Stokes and Improved Delayed Detached Eddy Simulation
DOI:
https://doi.org/10.15282/ijame.22.4.2025.6.0983Keywords:
Platoon, Drag, CFD, URANS, IDDES, Hybrid RANS-LESAbstract
The aerodynamic interaction of vehicles in platoon formation generates complex unsteady flow phenomena that strongly influence drag performance. This study investigates the unsteady aerodynamic drag and associated flow structures of two simplified Ahmed body models (30° slant angle) traveling in platoon using transient Computational Fluid Dynamics (CFD). Unsteady Reynolds-Averaged Navier–Stokes (URANS) and Improved Delayed Detached Eddy Simulation (IDDES) are employed to analyze the effect of longitudinal spacing ratios (d/L) ranging from 0.1 to 2.0. Following a mesh independence study, a grid with 13.3 million cells is adopted to resolve the flow field and quantify drag unsteadiness for both the lead and trailing vehicles across spacing configurations. Validation is performed by comparing the predicted drag coefficients with experimental measurements. Results show that the lead vehicle experiences a substantial drag reduction, with the coefficient decreasing to 0.16 at close spacing, before rising to 0.40 (URANS) and 0.37 (IDDES) at d/L=2. In contrast, the trailing vehicle exhibits only minor drag variation over d/L = 0.5–2, ranging from 0.35 to 0.37. Additional analyses include pressure coefficient distributions, instantaneous velocity fields, and vortex structures identified through Q-criterion visualizations. Comparisons indicate that IDDES captures finer flow structures and better reflects the unsteadiness of drag than URANS. Overall, the results suggest that the lead vehicle benefits most from platooning, achieving up to 60% drag reduction at small spacings, whereas the trailing vehicle gains comparatively little.
References
[1] K.. Y. Liang, J. Martensson, and K. H. Johansson, “Heavy-duty vehicle platoon formation for fuel efficiency,” IEEE Transactions on Intelligent Transportation Systems, vol. 17, no. 4, pp. 1051–1061, 2016.
[2] J. Törnell, S. Sebben, and D. Söderblom, “Influence of inter-vehicle distance on the aerodynamics of a two-truck platoon,” International Journal of Automotive Technology, vol. 22, no. 3, pp. 747–760, 2021.
[3] H. Dong, J. Shi, W. Zhuang, Z. Li, and Z. Song, “Analyzing the impact of mixed vehicle platoon formations on vehicle energy and traffic efficiencies,” Applied Energy, vol. 377, p. 124448, 2025.
[4] J. Luo et al., “Review on aerodynamic characteristics and energy recovery of vehicle platoon,” Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, vol. 239, no. 1, pp. 11–38, 2025.
[5] A. Yudianto, H. Sofyan, N. A. Fauzi, and others, “Aerodynamic characteristics of overtaking bus under crosswind: CFD investigation,” CFD Letters, vol. 14, no. 8, pp. 20–32, 2022.
[6] J. Luo, Y. Tie, K. Mi, Y. Pan, L. Tang, Y. Li, et al., “Aerodynamic optimization of mixed platoon Ahmed body vehicles based on response surface method,” International Journal of Numerical Methods for Heat & Fluid Flow, vol. 34, no. 1, pp. 309–333, 2024.
[7] A. Yudianto, W. Setiawan, F. Julianto, and U. Aminudin, “Aerodynamic study of vehicles in formation under crosswind,” in AIP Conference Proceedings, AIP Publishing, 2023, p. 020002.
[8] M. G. Connolly, A. Ivankovic, and M. J. O”Rourke, “Drag reduction technology and devices for road vehicles-A comprehensive review,” Heliyon, vol. 10, no. 13, p. e33757, 2024.
[9] S. Polek, “Development of a Passive Drag Reduction Modification for the 25° Ahmed Body using Large Eddy Simulation,” UNLV Theses, Dissertations, Professional Papers, and Capstones, University of Nevada, Las Vegas, 2024.
[10] B. Wang, H. Chen, Z. Huang, and H. Lou, “Large eddy simulation of active flow control for aerodynamic drag reduction in vehicle platooning,” Physics of Fluids, vol. 37, no. 5, p. 055112, 2025.
[11] G. Zhang, X. Song, X. Hu, J. Wang, T. Yu, P. Guo, et al., “A review on the drag reduction of Ahmed body,” Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, p. 09544070241307072, 2025.
[12] A. Altinisik, O. Yemenici, and H. Umur, “Aerodynamic Analysis of a Passenger Car at Yaw Angle and Two-Vehicle Platoon,” Journal of Fluids Engineering, vol. 137, no. 12, p. 121107, 2015.
[13] A. Yudianto, I. W. Adiyasa, and A. Yudantoko, “Aerodynamics of bus platooning under crosswind,” Automotive Experiences, vol. 4, no. 3, pp. 119–130, 2021.
[14] J. Cerutti, G. Cafiero, and G. Iuso, “Aerodynamic drag reduction by means of platooning configurations of light commercial vehicles: A flow field analysis,” International Journal of Heat and Fluid Flow, vol. 90, p. 108823, 2021.
[15] R. M. Pagliarella, S. Watkins, and A. Tempia, “Aerodynamic performance of vehicles in platoons: the influence of backlight angles,” SAE Technical Paper, 2007-01–1547, 2007.
[16] S. Watkins and G. Vino, “The effect of vehicle spacing on the aerodynamics of a representative car shape,” Journal of Wind Engineering and Industrial Aerodynamics, vol. 96, no. 6, pp. 1232–1239, 2008.
[17] A. Yudianto, U. Aminudin, W. Setiawan, and F. Julianto, “Aerodynamic investigation of misaligned four-vehicle platoon,” in AIP Conference Proceedings, AIP Publishing, 2023, p. 020031.
[18] S. D. Marshall, K. Snape, D. Soper, M. Sterling, and S. Gillmeier, “The aerodynamic performance of a platoon of lorries in close-proximity during an overtaking manoeuvre,” Frontiers in Future Transportation, vol. 5, p. 1356539, 2024.
[19] J. Luo, M. Li, K. Mi, Z. Liang, X. Chen, L. Ye, et al., “Research on aerodynamic characteristics of vehicle platoon under crosswind conditions based on Ahmed body,” International Journal of Numerical Methods for Heat & Fluid Flow, vol. 34, no. 7, pp. 2766–2807, 2023.
[20] S. R. Ahmed, G. Ramm, and G. Faltin, “Some salient features of the time-averaged ground vehicle wake,” SAE Technical Paper, no. 840300, p. 34, 1984.
[21] D. Wang, C. Xia, Q. Jia, and Z. Yang, “Effects of Vehicle Numbers and Vehicle Types on Drag Reduction of Platoons with Different Front-Edge Radius,” SAE Technical Paper, 2023-01–0951, 2023.
[22] D. Pi, P. Xue, W. Wang, B. Xie, H. Wang, X. Wang, et al., “Automotive platoon energy-saving: A review,” Renewable and Sustainable Energy Reviews, vol. 179, p. 113268, 2023.
[23] P. Spalart and S. Allmaras, “A one-equation turbulence model for aerodynamic flows,” in 30th Aerospace Sciences Meeting and Exhibit, 1992, p. 439.
[24] M. S. Gritskevich, A. V. Garbaruk, J. Schütze, and F. R. Menter, “Development of DDES and IDDES formulations for the k-ømega shear stress transport model,” Flow, Turbulence and Combustion, vol. 88, pp. 431–449, 2012.
[25] M. L. Shur, P. R. Spalart, M. K. Strelets, and A. K. Travin, “A hybrid RANS-LES approach with delayed-DES and wall-modelled LES capabilities,” International Journal of Heat and Fluid Flow, vol. 29, no. 6, pp. 1638–1649, 2008.
[26] I. Kohri, T. Yamanashi, T. Nasu, Y. Hashizume, and D. Katoh, “Study on the transient behaviour of the vortex structure behind Ahmed body,” SAE International Journal of Passenger Cars-Mechanical Systems, vol. 7, no. 2014-01–0597, pp. 586–602, 2014.
[27] T. Tunay, B. Sahin, and V. Ozbolat, “Effects of rear slant angles on the flow characteristics of Ahmed body,” Experimental Thermal and Fluid Science, vol. 57, pp. 165–176, 2014.
[28] H. Ebrahim and R. Dominy, “Wake and surface pressure analysis of vehicles in platoon,” Journal of Wind Engineering and Industrial Aerodynamics, vol. 201, p. 104144, 2020.
[29] P. Schito and F. Braghin, “Numerical and experimental investigation on vehicles in platoon,” SAE International Journal of Commercial Vehicles, vol. 5, no. 1, pp. 63–71, 2012.
[30] G. Romberg, F. Chianese, and R. Lajoie, “Aerodynamics of race cars in drafting and passing situations,” Racing Chassis and Suspension Design, vol. 90, p. 267, 2004.
[31] M. Zabat, N. Stabile, S. Farascaroli, and F. Browand, “The aerodynamic performance of platoons: A final report,” University of California, Berkeley, California, UCB-ITS-PRR-95-35, 1995.
Downloads
Published
Issue
Section
License
Copyright (c) 2025 The Author(s)
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
