Enhancing road stability with plastic waste in asphalt mixtures: A comparative study of dry and wet mixing methods

Authors

  • Ravlesya Dian Elaiza Wibowo Department of Mechanical Engineering, Faculty of Engineering and Technology, Sampoerna University, Jakarta 12780, Indonesia , Sampoerna University image/svg+xml https://orcid.org/0009-0002-0210-843X
  • Kushendarsyah Saptaji Department of Mechanical Engineering, Faculty of Engineering and Technology, Sampoerna University, Jakarta 12780, Indonesia , Sampoerna University image/svg+xml https://orcid.org/0000-0002-8821-5211
  • Farid Triawan Department of Mechanical Engineering, Faculty of Engineering and Technology, Sampoerna University, Jakarta 12780, Indonesia , Sampoerna University image/svg+xml https://orcid.org/0000-0002-9878-3167
  • Rindu Twidi Bethary Department of Civil Engineering, Sultan Ageng Tirtayasa University, Serang, Banten 42163, Indonesia , Sultan Ageng Tirtayasa University image/svg+xml
  • Wan Noor Hin Mior Sani Department of Civil Engineering, Politeknik Sultan Mizan Zainal Abidin, KM 08, Jalan Paka, 23000, Dungun, Terengganu, Malaysia , Politeknik Sultan Mizan Zainal Abidin image/svg+xml https://orcid.org/0000-0002-9876-8354

DOI:

https://doi.org/10.15282/construction.v6i2.14444

Keywords:

Plastic waste, Asphalt mixtures, Dry and wet methods, Modified asphalt, Marshall stability

Abstract

The incorporation of plastic into asphalt mixtures has gained attention as a potential approach to improving pavement performance. However, the comparative effects of plastic characteristics and mixing methods on asphalt mixture performance remain unclear. This study evaluates the influence of polyethylene terephthalate (PET) and low-density polyethylene (LDPE) as partial asphalt replacements through dry and wet mixing methods. Marshall testing was conducted to determine the optimum asphalt content (OAC) and assess mixture stability, flow, and volumetric properties, supported by polynomial regression and analysis of variance (ANOVA). Both SNI 2489:2018 and ASTM D6927-22 procedures yielded an OAC of 5.5%. PET achieved a maximum stability of 2286.50 kg at 5% substitution using wet mixing, while LDPE reached 2759.78 kg at 9% substitution using dry mixing, representing improvements of 28.42% and 55%, respectively. Statistical analysis revealed distinct effects on mechanical and volumetric properties depending on plastic type and mixing conditions. These findings demonstrate that asphalt modification effectiveness depends not only on plastic content but also on the interaction between material characteristics and incorporation methods, providing a comparative basis for optimizing plastic-modified asphalt mixtures.

Downloads

Download data is not yet available.

Downloads

Published

2026-11-18

Issue

Section

Articles

How to Cite

[1]
R. D. E. Wibowo, Kushendarsyah Saptaji, Farid Triawan, Rindu Twidi Bethary, and W. N. H. Mior Sani, “Enhancing road stability with plastic waste in asphalt mixtures: A comparative study of dry and wet mixing methods”, Constr., vol. 6, no. 2, p. In-Press, Nov. 2026, doi: 10.15282/construction.v6i2.14444.