Spectroscopic investigation of recycled PET modified with triacetin and ATBC plasticizers for sustainable polymer composite applications
DOI:
https://doi.org/10.15282/construction.v6i2.14239Keywords:
Spectroscopic analysis, Fourier Transform Infrared Spectroscopy (FTIR) , Polyethylene Terephthalate waste, Triacetin, Acetyl Tributyl CitrateAbstract
Plastic modification has emerged as a potential strategy for improving polymer processability and extending the functional use of recycled materials. Polyethylene terephthalate (PET) is widely used but presents significant environmental challenges because of its high durability and limited biodegradability. This study comparatively investigated the molecular-level interactions between recycled PET and two selected non-phthalate plasticizers, Triacetin and Acetyl Tributyl Citrate (ATBC), using Fourier Transform Infrared (FTIR) spectroscopy following thermal processing at approximately 300 °C. Triacetin was incorporated at 15, 30 and 40 wt.%, whereas ATBC was evaluated at 15 and 30 wt.%; the 40 wt.% ATBC formulation was excluded because a suitable intact specimen could not be obtained. FTIR spectra were analysed to identify changes in characteristic functional groups and to evaluate concentration-dependent spectral responses following plasticizer incorporation. Changes in the carbonyl, C–O, C–C–O and C–H absorption bands supported the physical incorporation of both plasticizers into the thermally processed PET system. The absence of new characteristic absorption bands suggested that the observed changes were predominantly associated with physical intermolecular interactions rather than the formation of new covalent functional groups. Semi-quantitative FTIR peak-ratio analysis further demonstrated concentration-dependent variations in selected absorption bands. At 30 wt.% plasticizer loading, the normalized C=O, C–O and C–C–O peak ratios were 1.20, 1.18 and 1.12, respectively, for Triacetin-modified PET, compared with 1.35, 1.30 and 1.25 for ATBC-modified PET. These results indicate that ATBC produced a higher normalized spectral response than Triacetin at the same concentration; however, the differences should not be interpreted as conclusive evidence of superior plasticization efficiency or long-term stability. The findings provide preliminary molecular-level insight into the interactions between recycled PET and the selected plasticizers. Further thermal, rheological, mechanical, migration, ageing and durability assessments are required to determine the practical suitability of modified PET for polymer concrete and other construction composite applications.
Downloads
Downloads
Published
Issue
Section
License
Copyright (c) 2026 The Author(s)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

