Vol. 19 No. 4 (2022): December

Articles

• Passive Flow Control of Ahmed Body using Control Rod

  A. Şumnu

  10063-10072

  • PDF

• Effect of Tool Shoulder-to-Pin Diameter Ratio (D/d) on the Mechanical Properties of Friction Stir Processed Mg-Micro Al₂O₃ Composite

  M. R. A. Mohd Reduan, Z. Zulkifli, Z. Hamedon, N. Fatchurrohman

  10103-10111

  • PDF

• Throttling Effect on the Performance and Emissions of a Multi-Cylinder Gasoline Fuelled Spark Ignition Engine

  Khalaf Ibrahim Hamada, M. F. Rahim, M. M. Rahman, R. A. Bakar

  10084-10093

  • PDF

• Effects of Solutionizing and Aging Alteration on Tensile Behavior of Stir Cast LM4-Si3N4 Composites

  D. Srinivas, G. Shankar, S. Sharma, A. Kini, M. Shettar

  10121-10131

  • PDF

• Numerical Analysis for Different Masks of Car Design of High-Speed Train

  B. Halfina, Hendrato, Y.P.D.S. Depari, Muhammad, S.H.M. Kurnia, H.A. Fitri

  10144-10151

  • PDF

• Numerical Investigation of Aerodynamic Characteristics of Hyperloop System Using Optimized Capsule Design

  Prokash Chandra Roy, Arafater Rahman, Mihir Ranjan Halder

  10132-10143

  • PDF

• Comparison of Transfer Function Models to Represent the Correlation Between Vehicle Lateral Acceleration and Head Tilting Angle in Motion Sickness

  Yassir Ali, Sarah 'Atifah Saruchi

  10039-10049

  • PDF

• The Ability of Selected Plants to Absorbing CO₂, CO and HC from Gasoline Engine Exhaust

  A. Syuhada, M.I. Maulana, R. Sary

  10094-10102

  • PDF

• The Effect of Wearing Soccer Headgear on the Head Response in Soccer Heading

  F.Y. Tan, M.H.A. Hassan, N.H. Johari, M.N. Omar, I. Hasanuddin

  10112-10120

  • PDF

• Utilization of Minimum Quantity Lubrication (MQL) Chip Fan on SS304 During Milling Process to Increase Carbide Tool Life

  A. Sifa, T. Endramawan, D. Suwandi, M.P. Putra, M.A. Amat

  10073-10083

  • PDF

• Performance of Autonomous Vehicles in Mixed Traffic under different Demand Conditions

  M. Azam, S.A. Hassan, O.C. Puan, S.F. Azhari, R.U. Faiz

  10050-10062

  • PDF