Enhancing competencies in instrumentation and measurement through project-based learning: A case study of an automated car reversing system

Authors

  • Dwi Pebrianti Department of Mechanical Engineering, Kulliyyah of Engineering, International Islamic University Malaysia, 53100, Gombak, Selangor, Malaysia , International Islamic University Malaysia image/svg+xml https://orcid.org/0000-0001-9938-5219
  • Luhur Bayuaji Faculty of Information Technology, Universitas Budi Luhur, Jl. Ciledug Raya, Petukangan Utara, Jakarta, Indonesia , Universitas Budi Luhur image/svg+xml
  • Ahmad S. Shamsudin Department of Mechanical Engineering, Kulliyyah of Engineering, International Islamic University Malaysia, 53100, Gombak, Selangor, Malaysia , International Islamic University Malaysia image/svg+xml
  • Ahmad H. Ahmad Hilmy Department of Mechanical Engineering, Kulliyyah of Engineering, International Islamic University Malaysia, 53100, Gombak, Selangor, Malaysia , International Islamic University Malaysia image/svg+xml
  • Muhammad A. P. Awang Abdul Hisham Department of Mechanical Engineering, Kulliyyah of Engineering, International Islamic University Malaysia, 53100, Gombak, Selangor, Malaysia , International Islamic University Malaysia image/svg+xml
  • Muhammad A. A. Mohd Rozailil Department of Mechanical Engineering, Kulliyyah of Engineering, International Islamic University Malaysia, 53100, Gombak, Selangor, Malaysia , International Islamic University Malaysia image/svg+xml
  • Rosdiyana Samad Faculty of Electrical & Electronics Engineering Technology, Universiti Malaysia Pahang Al-Sultan Abdullah, Pekan 26600, Pahang, Malaysia , Universiti Malaysia Pahang Al-Sultan Abdullah image/svg+xml https://orcid.org/0000-0003-0508-7718

DOI:

https://doi.org/10.15282/mekatronika.v8i2.13889

Keywords:

Project-Based Learning, Instrumentation and Measurement, Active Control, Ultrasonic Sensor, Engineering Education

Abstract

Necessary in today’s engineering programs. The present study provides an example of how project-based learning (PBL) was implemented in the Instrumentation and Measurement course, MECH 2241, by developing an Automated Car Reversing System with Emergency Brake. In developing this project, students demonstrated their ability to utilize all the course outcomes related to sensors, actuators, signal conditioning, and performance evaluation of a system through the integration of sensing, signal conditioning, embedded programming, and control logic. Students utilized an Arduino Mega, an HC-SR04 ultrasonic sensor, a buzzer, a motor driver, and a DC motor to build a prototype that provided an audible warning and ultimately stopped the motor if an obstruction was found, within 20 centimeters. Experimental research demonstrated that the prototype, after calibration according to the 97.25% average accuracy (y = 0.0172x + 0.8377), achieved the course outcomes stated above. Additionally, a results-based questionnaire was administered to assess the students’ opinion of the PBL project, with 91.1% of the 45 respondents agreeing or strongly agreeing that they gained a better appreciation for the relationship between measurement theory and engineering practice through this hands-on projected. PBL has positively impacted the students’ technical knowledge of instrumentation and measurement and has increased their engagement in and relationship with higher education institutions.

Downloads

Published

2026-11-06

Issue

Section

Research Article

How to Cite

[1]
Dwi Pebrianti, “Enhancing competencies in instrumentation and measurement through project-based learning: A case study of an automated car reversing system”, Mekatronika : J. Intell. Manuf. Mechatron., vol. 8, no. 2, p. In-Press, Nov. 2026, doi: 10.15282/mekatronika.v8i2.13889.

Share